miter elbows

Miter elbow are commonly used in the large size pipe project and special places. Its bending radius is not fixed as the standard elbows, such as 1.5D 3D 5D etc. The Miter elbows is made by two or more pieces of pipes. We have had been done the miter elbows for nearly 30 years. We have more and more experienced workers to do this kind of pipe elbows. The miter elbows each part have a named length by the clients. We produce it according to the drawings. And we can also make drawings according to your requirement. The length of each short edge is generally less than 100mm. And for the dusty gas, the angle of each piece is less than 15 degrees. And the number of slices should be taken into account in terms of pipe diameter, rotation angle and cleanliness of the media. For clean media, the maximum rotation angle of a single chip should not be greater than 22.5 degrees, while the influence of welding should also be considered.